How Much Gravel for a French Drain Bed?

Updated 2026-10-27 · Yardly

Background and Pain Points

Most French drain guides tell you to “dig a trench, add gravel, lay pipe” and stop there. When the homeowner actually gets to the yard with a shovel, the real question surfaces: how many cubic yards of stone do I need to buy? Guessing here is expensive in both directions. Order too little and you’re making a second trip to the landscape supply yard mid-project, paying a second delivery fee. Order too much and you’re stuck with a pile of 3/4-inch crushed stone in the driveway that you can’t return.

The confusion usually comes from one bad assumption: that the gravel volume equals the trench volume. It doesn’t. The trench also contains the pipe itself, the filter fabric, and — critically — the top 6 to 12 inches of soil or sod you put back on top. If you calculate stone using the full trench dimensions, you’ll over-order by 25 to 40 percent.

There’s a second, quieter pain point that costs more in the long run: undersizing the bed under and around the pipe. A French drain doesn’t just move water through the pipe — the stone envelope is a storage reservoir that holds water during a storm surge and releases it slowly. Skimp on that envelope and the system backs up, ponds at the surface, or freezes solid in a cold climate. Getting the number right is a fifteen-minute calculation that determines whether the drain works for twenty years or fails in two.

Why It Matters (Core Value)

Gravel is the single largest material line item in a French drain, and the calculations drive three outcomes:

Cost control. Clean 3/4-inch crushed stone runs roughly $30–$60 per cubic yard delivered in bulk, but $5–$8 per 0.5-cubic-foot bag at a home center. A 100-foot run needs close to 4 cubic yards — around $150 in bulk versus well over $500 in bags. Knowing your volume before you shop tells you which channel to use.

Hydraulic performance. Clean, washed crushed stone has roughly 30–40 percent void space. That means 1 cubic yard of stone holds about 0.35 cubic yards of water — around 70 gallons. A 100-foot drain with a proper bed stores about 275 gallons in the stone envelope alone, independent of the pipe. That storage buffer is what carries you through a heavy rain event.

Labor planning. Stone weighs about 1.4 tons per cubic yard. Four yards is 5.6 tons — roughly 35 to 40 wheelbarrow loads. You want that number known before you start, not discovered halfway through.

How to Do It Right (Step-by-Step)

Step 1: Set the trench width

A 4-inch pipe needs a 12-inch-wide trench minimum so stone can sit on both sides of it. Corrugated 4-inch HDPE has an outside diameter near 4.6 inches, leaving roughly 3.5 inches of stone per side. In heavy clay or where the trench walls slump, go to 15 or 18 inches. Wider is more forgiving to build but multiplies your stone order — 18 inches wide uses 50 percent more gravel than 12 inches.

Step 2: Set the depth stack

This is what separates the bed calculation from the trench calculation:

  • Bed below pipe: 4 to 6 inches of stone (4 is
Advertisement